Gemini Grabfast Roofing EPDM Contact Spray Adhesive

Gemini Grabfast Roofing EPDM Contact Spray Adhesive has been specifically formulated for bonding EPDM rubber roofing membranes. Using technically advanced resins it can withstand the extremes of temperature a rubber roof has to endure in its lifetime. With its fully controllable spray gun it is the cleanest way to adhere rubber membranes on the market today. There is no wastage in the canisters and no down time as the two substrates can be brought together as soon as the adhesive has flashed off. The whole system is fully portable and the canisters themselves are completely self-pressurised. Traditional methods of adhering a rubber roof are becoming archaic. They are slow, messy and labour intensive. The adhesive often taking a while to flash off especially in cold conditions. Grabfast Roofing is the opposite. It’s quick, clean and affordable so order one today.

Application

All substrates should be dry, clean and dust free. Holding the gun parallel to the work surface and apply an even coat of adhesive aiming for 80% – 100% coverage to achieve the perfect bond. Do not allow the adhesive to puddle or concentrate in one area. If you need to, please ensure that the first coat is dry before applying the second coat. Where possible spray one surface horizontally and the other vertically to create a cross hatch when brining the two sides together. Remember that all Grabfast products are contact adhesives and forms a bond by adhering to itself, so there must be adequate adhesive applied to each substrate to be bonded. IMPORTANT – It is the users responsibility to ensure that the chosen Grabfast product is suitable for the application before use. The adhesive is dry when there is no transferrance to the finger. Bring the two sides together and using a EX-roller, apply uniform pressure. Never bring the surfaces together, or apply a second coat prematurely as solvent will be trapped causing bubbles overtime.

Please check out our videos for more information on how to spray and setup a new canister.

Troubleshooting:

NEVER TURN THE CANISTER OFF UNTIL READY TO CONNECT TO A NEW CANISTER. TURNING IT OFF PREMATURELY COULD RESULT IN THE HOSE AND GUN BECOMING BLOCKED.

If the gun will not spray:

• Check the valve is turned on at the canister
• Make sure the gun wheel is wound open
• Using a spanner, remove the large front nut which secures the brass spray tip in place
• With the spray tip removed, attempt to spray the gun
• If the glue sprays, your brass tip is blocked. Please clean with Citrus cleaner and replace, or fit a new spray tip
• If there is still no flow, you have a blockage in your hose, usually caused by turning off the canister prematurely or not using the product for an extended period of time. Please contact us for guidance on how to safely remove your hose from the canister.

Spluttering or inconsistent spray pattern?

• Turn off the valve on the canister and by pulling the trigger on the gun, drain off any product in the hose.
• If your canister is cold, and been subjected to temperatures of below 15c please acclimatise the canister before turning back on. Please click here for more information on cold weather and storage.(link to cold weather page)
• Once your canister is at the optimum temperature, turn the canister on and pull the trigger on the gun to release a fresh flow of adhesive.
• Your spray pattern should now be working perfectly. If the problem still remains, please contact us for further advise.
• PLEASE NOTE – Using your canister with an inconsistent spray pattern can cause imbalances in the canister and may have negative effects on our your final bond.